Max Pressure:

Max Pressure:

Max Pressure:

In Use:

Max Pressure:

In Use:

In Use:

In Use:

Compressor Manufacturer:

Compressor Model:

Compressor ID:

Max RPM:

Stroke (inches):

Rod Diameter (inches):

Max Discharge Pressure (PSI):

Check Valve Size:

Provide New Shutdown Protection:

Gas Condition:

General Information Section

Compressor Section

Cylinder Section

Replace Lube Box

Lube Box Manufacturer

Lube Box Model

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

8 Throw Compressor

with Tandem

Company Name:

Phone:

Address:

City:

State:

Zip Code:

Email:

Replace Pumps

Pump Manufacturer

Pump Model

Oil Supply

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Suction Valve Flushing:

Cylinder Bore (inches):

Lube Points To Cyl:

Lube Points To Packing:

Max Pressure:

Packing in Use:

Max Pressure:

In Use:

In Use:

Max Pressure:

Max Pressure:

Max Pressure:

In Use:

In Use:

T

Optional Evaluation of Current Compressor:

You can additionally have your current compressor lubrication system analyzed for over or under lubrication conditions.


The 'Simple Eval' only requires that you enter information on the top level divider blocks fed directly from a pump.


'Advanced Eval' will require that you enter data for each divider block in the system along with the destination of each block output. The 'Advanced Eval' will catch problems where parts of the compressor are over lubricated and parts are under lubricated but they average out to a total lube within tolerances.


You can skip this step entirely and simply click on the 'Click to Send'


The form entries in red above need to be completed before you can submit this form.
Having issues? Technical Support: tech support Design Support: design support